| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
2. Once spa is filled, start equipment following the manufacturer’s directions. 3. Balance spa water with SpaGuard® Total Alkalinity Increaser and Calcium Hardness Increaser. Follow label directions or recommendations from your SpaGuard computerized water analysis. 4. Add the following amounts of SoftSoak® products per
150 gallons of spa water: 5. Add 1 ounce of SoftSoak Sanitizer per 150 gallons of spa water and circulate continuously again for approximately 30 minutes. 6. Using SoftSoak Water Test Strips, check your SoftSoak
Sanitizer level and pH. The sanitizer level should be between 30 and 50
ppm and the pH should be within 7.4 * Under normal conditions, Soft Soak Spa Conditioner will not have to be
reapplied until the spa is drained and refilled.
1. Using SoftSoak Water Test Strips, test the pH,
total alkalinity, calcium hardness and sanitizer levels of your spa. Write
down the results. 2. Add the following amounts of SoftSoak products
per 150 gallons of spa water: 3. The SoftSoak Sanitizer levels should be 30 - 50
ppm. If sanitizer level is 11 - 30 ppm, add 4. If pH is outside 7.2 to 7.6, adjust as needed with Spa Guard pH Increaser or pH Decreaser to 7.4. 5. Circulate for 30 minutes with the blowers off. Recommended Balancing Parameters
|
1.
Fill spa with water.